Accton Technology SwitcHub-2s Instalační manuál stáhnout pdf (Strana 6)

Quick Installation v

Quick Installation

The SwitcHub-2s contains 2 Ethernet ports, each of which supports 100BASE-TX

or 10BASE-T connections, operating at full or half-duplex. The smart design

built into the front display panel and configure options, provides a friendly

interface that simplifies installation and network troubleshooting. If you are

already familiar with basic network operations, you should be able to install this

switch as described below:

1. Unpack the SwitcHub-2s.

2. Find a location close to the network devices you need to connect, and within

easy reach of an electrical outlet.

3. Connect workstations or servers to the MDI-X station ports.

4. Connect to other hubs via the MDI port.

5. Set the transmission mode for each port to full or half-duplex.

6. Verify network communications by ensuring that -

• you have made all the necessary connections

• you can access any connected resources

• the hub’s indicator LEDs are functioning properly

Note: For devices connected directly to either port on the switch, it will

automatically detect transmission speed (10/100 Mbps). However, unless

the connected devices are operating at half-duplex (i.e., system default), you

will have to manually set the transmission mode via the configure button.

(Refer to Full/Half Duplex Mode Selection in Chapter 2).

If you encounter any problems in installing the SwitcHub-2s, refer to Chapter 3 for

a detailed description of installation procedures, or to Appendix A for help in

troubleshooting.

1 2 3 4 5 6 7 8 9 10 11 ... 54 55

Žádné komentáře

Accton Technology SwitcHub-2s Instalační manuál Strana 6